Rohde & Schwarz SMAB-B92 - Page 665

Remote Control Commands
R&S
®
SMA100B
663User Manual 1178.3834.02 ─ 05
Usage: Query only
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
Sets the GPIB address.
Parameters:
<Address> integer
Range: 0 to 30
*RST: 28
Example: See Example "Finding out the used VISA ressource strings"
on page 654.
:SYSTem:COMMunicate:HISLip:RESource?
Queries the VISA resource string . This string is used for remote control of the instru-
ment with HiSLIP protocol.
Return values:
<Resource> string
Example: See Example "Finding out the used VISA ressource strings"
on page 654.
Usage: Query only
:SYSTem:COMMunicate:NETWork:IPADdress <IpAddress>
Sets the IP address.
Parameters:
<IpAddress> string
Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example "Retrieving information on network-related set-
tings" on page 654.
Manual operation: See "IP Address" on page 360
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
Selects manual or automatic setting of the IP address.
Parameters:
<Mode> AUTO | STATic
*RST: n.a. (factory preset: AUTO)
Example: See Example "Retrieving information on network-related set-
tings" on page 654.
SYSTem Subsystem