DescriptionCommand
Clear a specific layer in a specific
frame-buffer.
1. Press Layer ID and use the Layer
ID knob to select the layer you want
to use.
2. Press Buffer ID and use the Buffer
ID knob to select the frame-buffer
you want to use.
ClearLayerFB
Move the current selection in the
Sequencer to the item below in the list.
Down
Set the Sequencer focus to a specific
template.
• Press Take ID and use the Take ID
knob to select the take id for the
template you want to load.
Focus
Perform a fade to black transition.FTB
Trigger a GPI.
• Use the GPI knob to select the GPI
that you want to use.
GPI
Turn a GPI on or off.
• Press GPI and use the GPI knob to
select the GPI that you want to use.
• Press State and use the State knob
to select whether to turn the GPI on
(On or 1) or off (Off or 0).
GPI w/State
This command is not implemented at this
time.
HELP
Perform a key only auto transition on the
selected ME.
1. Select the ME X that you want to
perform the transition on.
2. Select the Key X that you want to
transition.
KEYAUTO
Perform a key only cut transition on the
selected ME.
1. Select the ME X that you want to
perform the transition on.
2. Select the Key X that you want to
transition.
KEYCUT
Turn shaped keying on or off for the
selected key.
1. Select the ME X that you want set
the key for.
2. Select the Key X that you want to
change the state for.
3. Press State and use the State knob
to select whether the alpha is shaped
(On) or unshaped (Off).
KEYSHAPED
Returns whether a key is on-air or off-air
on an ME.
1. Select the ME X and Key X for the
key you want to get the sate for.
KEYSTATE
DescriptionCommand
Recall a switcher set.
1. Press Disk and use the Disk knob
to select the location of the set you
want to recall.
2. Press Set, enter the name of the set
you want to recall, and press Accept
New Name.
LOADSET
Perform an auto transition on the selected
ME.
1. Select the ME X(s) that you want to
perform the transition on.
MEAUTO
Perform a cut on the selected ME.
1. Select the ME X(s) that you want to
perform the transition on.
MECUT
Recall a memory.
1. Select the ME X(s) that you want to
recall the memory on.
2. Press Memory and use the Memory
knob to select the memory you want
to recall.
MEM
Store a memory.
1. Select the ME X(s) that you want to
store the memory on.
2. Press Memory and use the Memory
knob to select the memory you want
to store.
MEMSAVE
Enter a new mnemonic name for a source.
1. Select the type of source and use
the Src X knob to select the source
you want to name. You may have to
press the Src X to have the knob
appear.
2. Press Name, enter the name of the
set you want to store, and press
Accept New Name.
MNEM
Load a media item into a Media-Store.
1. Press GS, GSA, or ME and use the
GS, GSA, or ME knob to select the
Media-Store you want to load the
media item on.
2. Press Channel and use the Channel
knob to select the channel of the
selected Media-Store that you want
to load a media item on.
3. Press Media Number and use the
Media Number knob to select the
media item you want to load.
MS
92 • Custom Controls — Acuity Operation Manual (v9.2)
To Next Page
Loading...
Need help?
General
