Schenck process Disomat Opus User Manual

Function Variants Filling Scale
6.2 Filling Scale
6.2.1 General Functioning
Before operating a filling scale, make yourself familiar with the general
functioning of your DISOMAT.
The filling scale is designed to fill material from a surge hopper into a weigh hopper.
Single and multiple fill operations are possible.
Filling
DISOMAT controls a fill unit for filling in full feed and dribble feed until setpoint is
reached. the amount fed out is checked for tolerance; if required, make-up filling takes
place. In case of overfill, an event message is output.
To start filling,
• Press F1 key, or
• Set input contact 1, or
• Send EDP command or
• PLS contact.
To stop filling,
• Press F2 key, or
• Set input contact 2, or
• Send EDP command or
• PLS contact.
BV-H2313 GB 0630 DISOMAT
®
Opus – Operating Manual
- 94 - © Schenck Process GmbH, Darmstadt

Schenck process Disomat Opus Specifications

General

Brand	Schenck process
Model	Disomat Opus
Category	Control Panel
Language	English