Schenck process Disomat Opus User Manual

Function Variants Crane Scale
Parameter Name Default Required
Setting
Recommended
Setting
Comments
Source
Gross is block selects what quantity is issued at the analog
output and how it is scaled.
Some quantities and reference values are:
Th
Source
Dimension for Min/Max
Gross: The scale's dimension
Net: The scale's dimension
W/dt: The scale's dimension / h
Fieldbus: none; the IEEE value of the
PLS-AIn is issued
Controller magnitude: Not available in Opus; output is
set to 0
Setpoint: The scale's dimension
Actual value %: Percent of setpoint
Actual value of dim: The scale's dimension
Residual value %: Percent of setpoint
d
Residual value of dim: The scale's dimension
Next setpoint The scale's dimension
M
value
IN reference 0
MAX reference
value
0
Block 'PLS-AOut'
Reference value 20 = MAX reference Scaling the parallel output of the analog output to PLS
value
analog output 1.
Block 'Analog Output'
Analog output OFF 4 - 20 mA
6.4 Crane Scale
6.4.1 General Functioning
Before operating a crane scale, make yourself familiar with the general
functioning of your DISOMAT.
Ground-controlled crane scale:
Start basic functions via control unit (pendant or remote control). Output information
on weight and system status on large-size display. Enter all further settings on
DISOMAT keyboard.
Information from ground-controlled crane scale is output on large-size display
DLZ 055/DLZ 111 (weight value, error information, status messages):
Scale tared = Net
Scale exact zero = -0-
Printing active = Yellow LED
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 107 -

Schenck process Disomat Opus Specifications

General

Brand	Schenck process
Model	Disomat Opus
Category	Control Panel
Language	English