Schenck process Disomat Opus - Fct. 4332:Printer

Setting Mode Setting Using Configuration Password
Parameter Enter / Select Default
Protocol
Determines the EDP protocol to be
used for communication.
3964R (Siemens)
S5 (for Siemens SPS S5)
DDP8672 (e.g. for connection of a
legal-for-trade SCHENCK PC)
Mod-Bus *)
DDP8785
(MINPROZ)
3964R
Data Block (data block address)
Input is required only if a SIMATIC
S5 is connected. S5 enters data sent
from DISOMAT direct into data block.
0
Decimal Sign
Determines decimal sign used in
messages in case of floating points
numbers.
Comma (,)
Point (.)
Comma
(,)
*) Please note: Interfacing via Modbus can alternatively be set using function
'4334:Fieldbus' (look there).
Operating Sequence
Start function and enter scale number:
4331:EDPScale number
0
Select one of eligible EDP interfaces:
4331:EDPEDP Interface Off
Select interface protocol:
4331:EDPProtocol 3964R
Enter data block information:
4331:EDPData Block
0
Select decimal sign for floating point numbers:
4331:EDPDecimal point
(.)
Operate [OK] key and exit function. EDP interface is configured.
5.3.2.5 Fct. 4332:Printer
Use menu item to determine the physical assignment of printer interface to the
available interface outputs (S1 to S3) as well as the type of printer (local or remote).
NOTE: In addition, configure interface as such using menu item '432:Interfaces'.
ATTENTION: If interface assignment produces a conflict, system outputs an
event message.
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 65 -