DISOMAT Overview General Control
3.5.2.1 Operating Input/Output Dialogs
action required for system operation, dialogs
llow certain conventions.
hese are functions displaying current parameter values.
4,56') is displayed after the note (e.g. 'Balance'), the
function is an output function.
For you to easily recognize the kind of re
fo
Outputs
T
If the actual contents (e.g. '123
The a
• Wit
o me seconds; function terminates
• With mu lues are output one after the other.
o splayed; go to next value with [ENTER] key;
o seconds; function terminates
o er
special cases (such as displaying the version)
where you can also scroll over several lines with [UP arrow] and
[DOWN arrow].
ch as '
Fix
re re various types of output:
h single-part outputs, only one value is output:
o Value is permanently displayed; exit function with [OK] key.
Value is displayed for so
automatically
(e.g. 'a:Display Gross')
lti-part outputs, multiple va
Values are permanently di
exit function with [OK] key
(e.g. '6:Display Balance')
Value is displayed for some
automatically
(e.g. '52:Display Version')
You can use the [LEFT arrow] and [RIGHT arrow] to scroll in long
texts; there are some
Inputs
These are functions used to enter data in the dialog mode.
fact that the current value (suYou can identify an input mode from the
1') is
ext (such as 'Fixed tare' or 'Tare') and a cursor symbol
('underline') can be seen in the input space.
The a
•
The cursor is fixed at the first point of the input space. Select from list of
eligible values using the [LEFT arrow] and [RIGHT arrow] ke :
displayed after an instruction t
re re two types of input:
Input using scroll field (input by selection):
ys
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 21 -
To Next Page
Loading...
Need help?
General
