Schenck process Disomat Opus - Setting Using Configuration Password

Setting Mode Setting Using Configuration Password
5.3 Setting Using Configuration Password
After input of the Configuration Password, you can access
• 'Basic functionality' (see Item 4.2)
• Functions accessible with Parameter Password (see Item 5.2)
• Additional functions described below (see Table, Fig.).
Menu Items Comments
42:FUNCTION VARIANT
421:Parameters
423:Load variant
Load scale and set parameters
43:PERIPHERALS
431:National Settings
432:Interfaces
433:COMMUNICATION
4331:EDP
4332:Printer
4333:Secondary Display
4334:Fieldbus
434:Event classes
435:Analog Output Calibration
436:IP Configuration
Peripherals settings:
- Select dialog language
- Configure interfaces
-Settings for communication
-Change event classes
-Calibrate analog output
44:SCALE
441:Calibration Parameters
442:Mode
443:Configure L-f-T Memory
444:Scale Parameters
This menu comprises all scale calibration functions.
The functions on the left can be reached after input of
configuration password (without 445:CALIBRATION).
With functions 441, 442 and 443 you can read only;
with 444, also write. After input of calibration password,
you can access all functions.
NOTE: For details, see Item 5.4 (Setting Using
Calibration Password).
BV-H2313 GB 0630 DISOMAT
®
Opus – Operating Manual
- 60 - © Schenck Process GmbH, Darmstadt