Setting Mode Safety Through Password Protection
Every password is designed as 6-digit number.
To ease operation, the menu items relevant for the selected area do not
appear before sucessful password input.
We urgently recommend to use the password protected menu tree
areas only if you are sufficiently familiar with the function block
system.
With the use of the configuration password, for instance, function block
parameters can be changed. However, inadvertent changes can cause
severe faults, sometimes not immediately obvious. A connected control
system, if any, has the potential to cause severe injury or damage to the
machine.
The plant user must ensure that the passwords are used only by
authorized and skilled persons. If required, passwords must be removed
from operating manual, or changed.
5.1.1 Default Passwords
If you make this manual available to operators who shall not know all passwords, we
suggest to
• blacken this table, or
• change passwords (see menu item '45:Change Password'), enter in copy of
this sheet and keep in a safe place.
Password for Default Changed to
Parameter Setting 393852
Configuration 618349
Calibration 505442
Restart 140789
5.1.2 Fct. 41:Password
Go to menu tree, use DIRECTION KEYS to open function
41:SETTINGS
Enter Password
and acknowledge with [ENTER] key.
Input field
41:Enter Password
Password: ______
opens. Enter requisite password. For safety reasons, display is suppressed.
BV-H2313 GB 0630 DISOMAT
®
Opus – Operating Manual
- 42 - © Schenck Process GmbH, Darmstadt
To Next Page
Loading...
Need help?
General
