Schenck process Disomat Opus - Fct. 7:Select Fixed Tare; Fct. 8:Manual Tare

Normal Mode Functionality in Menu Tree
O perating Sequence
ent balance total, e.g.
alance: +1256.0
Function first displays curr
6:Display Balance
B
After renewed operation of [ENTER] key, display shows current number of dumps,
nce
e.g.
6:Display Bala
Dumps: 7
You can use [OK] to get to the display of sums for materials 1 and 2.
lect from a list. List may comprise maximum 9 fixed tare values (Fix1 ... Fix9).
4.2.6 Fct. 7:Select fixed tare
Use menu item to tare a stored value, i.e. you need not key in tare value but can
se
Selection of a fixed tare weight with 0.00 value has the same effect as 'Clear
Tare'.
etting Mode' (Parameter password) using the '48:Fixed Tare input'
function.
perating Sequence
ield display always shows parameter 'Fix1'.
re
ixed tare
F
For simple selection of fixed tare values, these require to be entered. This is
done in 'S
O
After call of function, scroll f
7:Select fixed ta
F
ix1
Use DIRECTION KEYS to select other value, if y
[O
Example
You wish to acquire the weights of bulk solids (NET weight) stored in different hopper
types of 5 different weights. The weight of each hopper is always the same. You we
the filled hopper (GROSS weight) and select hopper weight
A
ou desire so. When you press the
K] key, the display goes back to net by (Net).
igh
using fixed tare value.
dvantage: You need not enter hopper weight in manual.
dmissible input range: [ 0 ... full scale value]
perating Sequence
Tare
4.2.7 Fct. 8:Manual tare
Use menu item to enter tare value in manual.
A
O
Input field displays current value of tare memory:
8:Enter Manual
Tare: +__0.00
E nter desired value and acknowledge with [ENTER].
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 37 -