Setting Mode Setting Using Calibration Password
5.4.2.10 Parameter 'Load Cell Rated Capacity'
Display: RatedCp 1000kg
1 - 999999 Input always
[kg]: Default = 1000
d.
If a load cell is loaded with its rated capacity, it will output as measuring
sign sponding to its load cell
cha ad Cell Characteristic in mV/V).
Comments: Ent acity indications with other units must be
conve
.4.2.11 Parameter 'Number of Load Cells'
in
Function: Indicates rated capacity of load cells use
al, at 1V supply voltage, the voltage corre
racteristic (Parameter Lo
er always in kg. Rated cap
rted into kg.
5
Display: No. of L/Cs 1
Input: Any value from 1 to 20
ut unit.
.2.12 Parameter 'Load Cell Characteristic'
Default = 1
Enter value witho
Function: Indicates number of load cells used.
Pivots, if any, do not count.
5.4
Display: L/C-C [mV/V] 2.85
Input: Any value from 0.1 to 10
n: aracteristic) indicates the output voltage
5.4.2.13 Parameter 'Dead Weight'
Display:
Default = 2.85
Load cell characteristic (rated chFunctio
(measuring signal) a load cell supplies as a function of supply voltage, if
loaded with its rated capacity.
Deadw. + 0.00kg
Any value fro
Default = 0.00
Dead weight means
Input: m 0 to ± 999999
Function: the weight of scale mechanics (weight of empty scale)
acting on load cells in addition to effective load, i.e. the load to be weighed.
Dead weight is acquired during dead weight calibration and stored as
calibration parameter Dead Weight.
Besides the Calibration Factor, it is one of the two parameters that need not
be entered.
Merely in theoretical calibration, correct dead weight value has to be
entered in manual.
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 79 -
To Next Page
Loading...