Setting Mode Setting Using Parameter Password
5.2.1.4 Fct. 464:String Name
In normal mode, the operator can use function '2:Enter String'' to enter data for max. 5
strings. These data appear on printout in place of code 'BZ' or 'BZn' (with n=1...5). To
protect formatting from inappropriate operator input, limit input length and inform the
operator about the desired contents by a suitable hint.
Enter here
• maximum number of input digits (boundary condition 1)
• input hint for the operator (boundary condition 2).
Operating Sequence
Since 5 different strings can be used in DISOMAT, first enter number of string whose
boundary conditions you wish to set (admissible values: 1 to 5):
464:String Name
String Number 1
Input field for first boundary condition opens:
464:String Name
Length: 12
If need be, change admissible length (e.g. to 12 digits).
Operate (ENTER] key to go to second boundary condition input field:
464:String Name
Prompt: Customer:____
If need be, edit hint as desired (e.g. 'Customer:'). This string may have max. 11 digits.
Added automatically, a blank at the end needs not be considered.
Acquire changes with [OK] key.
Follow these steps for input of residual string numbers.
Example:
You wish the operator to receive the input prompt 'Material:' and know that maximum
two digits can be entered. Determine:
• Length: 2
• Input hint: 'Material:'
Upon string input, the operator receives the display below and can enter maximum
two digits: 'Material: __'.
BV-H2313 GB 0630 DISOMAT
®
Opus – Operating Manual
- 52 - © Schenck Process GmbH, Darmstadt
To Next Page
Loading...
