Schenck process Disomat Opus - Operating Activities

Function Variants Cargo Scale
6.5.5 Operating Activities
This item explains the regular operating activities, i.e.
• Enter manual tare
• Enter string
• Print weigh data.
For other regular operating activities, see manual BV-H2313, Item 4.2, i.e.
• Select fixed tare
• Acknowledge error.
Enter Manual Tare
With the cargo scale, you can enter the tare value in manual
• using function key F1
• in menu tree using menu item '8:Manual tare'
The type of input is the same in either case.
Enter String
With the cargo scale, you can enter string
• using function key F2
• in menu tree using menu item '2:Enter String'
The type of input is the same in either case.
Print Weigh Data
There are three types of printout and one print repeat.
Single Printout
Start single printout after weighing using [SHIFT]+[F1] (function key F4), with unit load
being positioned on scale.
Single printout uses form format 1.
For details on form format, see manual BV-H2313, Item 5.2.
Totals Printout
After one (or multiple) weighing operation(s), start totals printout with [SHIFT]+[F3]
(function key F6). Totals printout clears balance memory, i.e. number of weighing
operations and totals value are reset. For totals printout, system uses form format 3.
Sub-Totals Printout
After one (or multiple) weighing operation(s), start sub-totals printout using menu item
'33:Print3'. Form of printout is the same as with totals printout, however, balance is
not reset.
Repeat Printout
Repeat last printout as many times as required using [SHIFT]+[F2] (function key F5),
e.g. if you need a copy of if printout was faulty.
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 117 -