Schenck process Disomat Opus - Fct. 461:Form Texts; Fct. 462:Form Formats

To Next Page

To Previous Page

Setting Mode Setting Using Parameter Password

5.2.1.1 Fct. 461:Form Texts

For creation of image, the '462:Form Formats' function uses various codes. Using

code 'Sn' (n=1,2,3) one of three form texts can be inserted.

Form texts are preassigned as default. If other texts are required, you can match

these to your requirements using the described functions, and reload the default

settings at any time (see function: '469:Load Default Text').

Operating Sequence

Input field for first form text opens, e.g.

461:Form Texts

1st Text: Date____Time_______Cons.No.____

If need be, enter string and/or go to second or third form text using the [ENTER] key.

461:Form Texts

2ndText: Veh.No._______________________

461: Form Text

3rd Text: Weight___________________

Acquire changes with [OK] key.

Note: If you need more form texts, simply add text to form format (see '462:Form

Formats').

5.2.1.2 Fct. 462:Form Formats

The form formats below correspond to relevant function block and menu tree

functions:

Form Format Function Block Menu Tree Function

Form Format 1 Print1 '31:Print 1'

Form Format 2 Print2 '32:Print 2'

Form Format 3 Print3 '33:Print 3'

Form Format 4 Print4 '36:Print 4'

Form Format 5 Print5 '37:Print 5'

Form Format 6 Print6 '38:Print 6'

You can match these form formats to your requirements using the function described

here.

You can, e.g.

• Change form division

• Determine weigh data to be printed, e.g. Gross, Net, Tare, Balance)

• Determine additional texts to be printed.

Tip - You can output the stored system formats using menu item '56:Print

Parameters'. With the aid of the printout, changes are easier to perform.

NOTE: If no changes have been effected, system uses its default formats (see

function '468:Load Default Form').

DISOMAT

Opus – Operating Manual 0630 BV-H2313 GB

Related product manuals