Schenck process Disomat Opus User Manual

Function Variants Discharge Scale
Parameter Name Default Required
Setting
Recommended
Setting
Comments
Main contact 0.0 with reference to setpoint, e.g. 5 kg; switchi ng threshold
= 95 kg
Tolerance 0.0 Tolerance
Pre-contact <
Optimization factor 0.0 2 Valid if function block parameter 'Optimiz ion=Yes' 0. at
Parameters of the function set via '421:Parameter' (with parameter password when
commiss or vi DIS
variant; can be
OPLAN ioning) a
Block 'Discharge W ingeigh '
MaxFillWeight
ngle
eding:
xFillWeight
etpoint
ing bin 0.0
Si
fe
Ma
> S
The maximum weight in the weigh
FillWeight 0.0
Optimization No Start/stop optimization (Yes/No)
No-Motion Time 20.0 The maximum ter
eding.
time it waits for no-motion state af
fe
Timeout 0.0
0 sec: Tare memory is not cleared after
feeding
> 0 sec: Tare memory cleared after input
time. Restart only possible after
this time.
Settling time: 0.0
bbl
Ti
dr
me that can
opping (dri
be set between the main contact
e feed) and tolerance check
Block 'Single Printout'
Timeout 0.0
0 sec: tate Print-out without no-motion s
monitoring
Waiting-time to no-motion state. 1-999 sec:
Printing option OFF
o
:
'Balance': Balance before printout
system/bal
ance':
Balance before printout and
output data to the data
processing system after printout
'OFF': No data output to the data
processing system and n
balancing
Data output to the data
processing system after printout
'to data
processing
system'
'data
processing
Block 'Print Total'
Timeout 0.0
Printing option
see above
OFF
Block 'Print Balance'
Timeout
Printing option
0.0
OFF
see above
Block 'Analog Source'
BV-H2313 GB 0630 DISOMAT
®
Opus – Operating Manual
- 106 - © Schenck Process GmbH, Darmstadt

Schenck process Disomat Opus Specifications

General

Brand	Schenck process
Model	Disomat Opus
Category	Control Panel
Language	English