701 Motor Protection Relay Date Code 20010719
Event Analysis
Sequential Events Recorder (SER) Report
9.14
Table 9.6 Retrieving SER Reports (Continued)
Example
SER Serial
Port Commands
Format
SER 17 If you enter the
SER
command with a single number
following it, the relay displays that number of rows, if they
exist. The rows display with the oldest row at the beginning
(top) of the report and the newest row (Row 1) at the end
(bottom) of the report. Chronological progression through the
report is down the page and in descending row number.
SER 10 33 If you enter the
SER
command with two numbers following it,
the relay displays all the rows between (and including) Rows
10 and 33, if they exist. The rows display with the oldest row
(Row 33) at the beginning (top) of the report and the latest row
(Row 10) at the end (bottom) of the report. Chronological
progression through the report is down the page and in
descending row number.
SER 47 22 If you enter the
SER
command with two numbers following it,
the relay displays all the rows between (and including) Rows
47 and 22, if they exist. The rows display with the row (Row
22) at the beginning (top) of the report and the oldest row
(Row 47) at the end (bottom) of the report.
Reverse
chronological progression through the report is down the page
and in ascending row number.
SER 3/30/97 If you enter the
SER
command with one date following it, the
relay displays all the rows on that date, if they exist. The rows
display with the oldest row at the beginning (top) of the report
and the latest row at the end (bottom) of the report, for the
given date. Chronological progression through the report is
down the page and in descending row number.
SER 2/17/97 3/23/97 If you enter the
SER
command with two dates following it,
the relay displays all the rows between (and including) dates
2/17/97 and 3/23/97, if they exist. The rows display with the
oldest row (date 2/17/97) at the beginning (top) of the report
and the latest row (date 3/23/97) at the end (bottom) of the
report. Chronological progression through the report is down
the page and in descending row number.
SER 3/16/97 1/5/97 If you enter the
SER
command with two dates following it,
the relay displays all the rows between (and including) dates
1/5/97 and 3/16/97, if they exist. The rows display with the
latest row (date 3/16/97) at the beginning (top) of the report
and the oldest row (date 1/5/97) at the end (bottom) of the
report.
Reverse
chronological progression through the report
is down the page and in ascending row number.
To Next Page
Loading...
