Figure 106: Hole detection/hole size
•
≥n hole is larger than or equal to n beams:
The output becomes active when the configured number of beams or more are
made.
•
≤n hole is smaller than or equal to n beams:
The output becomes active when the configured number of beams or fewer are
made.
•
= n hole is equal to n beams:
The output becomes active if the exact number of configured beams are made.
The hole size that has been set is shown in the Simulation area. It can be changed using
the mouse.
Figure 107: Setting the hole size with the mouse
8
CONFIGURATION WITH SOPAS ET
118
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
