Figure 116: Classification of the hole position – larger than or equal to hole center
1
Made beam
2
Blocked beam
3
Configured beam
•
The hole center is smaller than or equal to the position of beam number n.
The number of the beam located in the center of the hole is smaller than or equal
to the number of the configured beam.
Figure 117: Classification of the hole position – smaller than or equal to hole center
1
Made beam
2
Blocked beam
3
Configured beam
•
The hole center is equal to the position of beam number n.
The center of the hole is located exactly at the configured beam.
Figure 118: Classification of the hole position – equal to hole center
1
Made beam
2
Blocked beam
3
Configured beam
The hole position that has been set is shown in the Simulation area. It can be changed
using the mouse.
CONFIGURATION WITH SOPAS ET
8
8018748.1Q3I/2024-12-18 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet
123
Subject to change without notice
To Next Page
Loading...
