1
2
3
4
5
6
7
8
9
10
11
12
1
3
5
7
9
11
13
15
17
19
21
23
2
4
6
8
10
12
14
16
18
20
22
3
4
5 6 4
7
1 2
Figure 137: Left: Cross beam switching, right cross beam measuring
1
Cross beam switching
2
Cross beam measuring
3
Beam numbering for cross beam switching
4
Parallel beam
5
Crossing beams
6
Beam numbering for cross beam measuring
7
Crossing beams, displayed as a virtual beam
Example with cross beam measuring
A light grid with a beam distance of 20 mm can detect a wide object with a thickness
of 1 mm using the cross beam switching function, but cannot output a measured value
for the height, for example. With the cross beam measuring function, it is also possible
to output the height as a measured value.
Configuring the Cross beam switching function via SOPAS ET
►
In SOPAS ET, click on the Performance options expandable menu in the right-hand
window.
►
Activate the Cross beam switching function in the Scan mode area.
✓
The Cross beam switching function is activated.
8 CONFIGURATION WITH SOPAS ET
140
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
