Siemens CU240B-2 - Page 516

Index
Converter with the CU240B-2 and CU240E-2 Control Units
516 Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
OFF2 command, 171
OFF3 command, 171
Switch on
Motor, 171
ON command, 171
Switching on inhibited, 172, 196
Switching over units, 276
Switching-on a motor with BOP-2, 488
Switch-off signal paths, 339
Switch-on inhibit, 211, 214
Symbols, 23
System runtime, 404
T
Technical data
Control Unit, 423, 425
Technology controller, 198, 279, 308
Telegram
Extending, 206
Temperature calculation, 269
Temperature monitoring, 262, 269
Temperature sensor, 95, 102
Temperature switch, 265
Terminal block, 115, 173
Terminal strip
Factory setting, 95, 102
Test signals, 337
Three-wire control, 185, 185
TN line system, 77
Torque accuracy, 134, 143, 153, 158
Trace function, 492
TT line system, 77
Two-wire control, 185, 185
Type plate
Control Unit, 27
Power Module, 27
U
Unit system, 279
Unwinders, 292
Update (firmware), 397
Upgrading the firmware, 392
Upload, 353, 363, 367
USB interface, 147
Use for the intended purpose, 27
User interfaces, 91
V
V/f characteristic, 237
V/f control, 486
VDC min controller, 304
Vector control, 248, 260, 486
Sensorless, 246
Version
Control Unit, 27
Firmware, 504
Hardware, 504
Power Module, 27
Safety function, 504
Vertical conveyors, 290
Voltage boost, 237, 238, 242, 244, 486
Voltage input, 178
W
Winders, 292
Wire breakage, 337
Wire-break monitoring, 179, 266, 267
Write protection, 370, 370
Z
Ziegler Nichols, 313
ZSW1 (status word 1), 197, 212, 215
ZSW3 (status word 3), 199