Siemens Hipath 5000 - Page 1212

Codes for Activating/Deactivating Features Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
B-8 HiPath 3000/5000 V9, Service documentation
fcodes.fm
Call detail re-
cording, atten-
dant (CDRA)
– – – – V – – – DIG x RK,
BS
Only if appropriate
authorization is as-
signed
Call recording
on
*493
TDM WpC with-
out display: pro-
grammed key
– – – V, T CMI
fea-
ture
han
dset
only.
– Fea-
ture
menu
AN, DIG, ENT,
CMI, IPSC
X RH,
BR,
WA,
RG,
BS,
RK
Only for authorized
stations
Call recording
off
#493
TDM WpC with-
out display: pro-
grammed key
– – – V, T CMI
fea-
ture
han
dset
only.
– Fea-
ture
menu
AN, DIG, ENT,
CMI, IPSC
X RH,
BR,
WA,
RG,
BS,
RK
Only for authorized
stations
Selective line
seizure
See numbering
plan
See
number-
ing plan
See
num-
ber-
ing
plan
– V – – See
num-
bering
plan
AN, DIG, ENT,
S0, CMI, IPSC
X – Only with trunk key
for prime line
Telephone lock for
outgoing lines only
Group call See numbering
plan
See
number-
ing plan
See
num-
ber-
ing
plan
– V – – See
num-
bering
plan
AN, DIG, ENT,
S0, CMI, IPSC
– – Group calls can be
programmed on
DSS key
Group call, join *85 7585 *85 – V, T RH U1 Fea-
ture
menu
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
All group calls, join =
*85*
Group call,
leave
#85 7685 #85 – V, T RH U1 Fea-
ture
menu
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
All group calls,
leave = #85#
Hold key – – – – V – – Mouse
click,
Key
DIG, ENT – –
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Supported
workpoint cli-
ents
(see abbrevi-
ations in
Table B-2)
Locking of
feature
Note
TDM work-
point clients
without dis-
play,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients
OpenScape
Personal Edition
Code +
Procedure
Code Code
Key Menu
Code
via
Telephone lock
Status
locking on
Fixed
Programm-
able
Dialog
Service
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu