Codes for Activating/Deactivating Features Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
B-10 HiPath 3000/5000 V9, Service documentation
fcodes.fm
Keypad dial – – *503 – – GS – Can be
dis-
played
DIG, CMI,
IPSC
– –
Conference
(up to 5 sta-
tions)
*3 753 *3 – V GS U1 Local
active
menu
AN, DIG, ENT,
S0, CMI, IPSC
– – Initiation from call
End confer-
ence (up to 5
stations)
#3 763 #3 – V GS U1 Local
active
menu
AN, DIG, ENT,
S0, CMI, IPSC
– RH,
BR,
WA,
RG,
BS,
RK
Status as prior to
conference call.
Dialog menu pro-
vides further options
for ending confer-
ence.
Call charge
display for own
station (GET)
– – *65 – V – H – DIG, IPSC X – Deletion only by
system administra-
tor
Save / change
speed dialing
system/indi-
vidual
*92+ISD
no.+Stn. no.
7592 *92... – – – H Local
ETD
feature
AN, DIG, ENT,
S0, CMI, IP-
SC, IPSI
X RK,
BS
ISD 0 ... 9
Mobile phones also
have an additional
local procedure
Using system
speed-dial
number
*7+ISD no. 757... *7... – V, U – H Local
ETD
feature
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
000 ... 999
Mobile phones also
have an additional
local procedure
Using station
speed-dial
number
*7+ISD no. 757... *7... – V, U – H Private
ETD
feature
AN, DIG, ENT,
S0, CMI, IP-
SC, IPSI
RK,
BS
ISD 0 ... 9
Trunk queu-
ing, automatic
– – – – V – – AN, DIG, ENT,
S0, CMI, IPSC
X RH,
BR,
RG,
RK,
GS
Automatically after
timeout if enabled in
the CDR
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Supported
workpoint cli-
ents
(see abbrevi-
ations in
Table B-2)
Locking of
feature
Note
TDM work-
point clients
without dis-
play,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients
OpenScape
Personal Edition
Code +
Procedure
Code
Code
Key Menu
Code
via
Telephone lock
Status
locking on
Fixed
Programm-
able
Dialog
Service
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu
To Next Page
Loading...
