Siemens SINUMERIK 808D Function Manual

Function Manual
136 01/2017
Number
Identifier
Name
24100
TRAFO_TYP_1
Type of 1st transformation, possibly with axis sequence
24110
TRAFO_AXES_IN_1
Axis assignment at input of 1st transformation
24120
TRAFO_GOEAX_ASSIGN_TAB_1
Geo-axis assignment for 1st transformation
24200
TRAFO_TYP_2
Type of 2nd transformation, possibly with axis sequence
24210
TRAFO_AXES_IN_2
Axis assignment at input of 2nd transformation
24220
TRAFO_GOEAX_ASSIGN_TAB_2
Geo-axis assignment for 2nd transformation
24800
TRACYL_ROT_AX_OFFSET_1
Deviation of rotary axis from zero position in degrees (1st TRACYL)
24810
TRACYL_ROT_SIGN_IS_PLUS_1
Sign of rotary axis for TRACYL (1st TRACYL)
24820
TRACYL_BASE_TOOL_1
Distance of tool zero point from origin of geo-axes (1st TRACYL)
24900 TRANSMIT_ROT_AX_OFFSET_1 Deviation of rotary axis from zero position in degrees (1st
TRANSMIT)
24910
TRANSMIT_ROT_SIGN_IS_PLUS_1
Sign of rotary axis for TRANSMIT (1st TRANSMIT)
24911
TRANSMIT_POL_SIDE_FIX_1
Limitation of working range in front of/behind pole, 1st transformation
24920
TRANSMIT_BASE_TOOL_1
Distance of tool zero point from origin of geo-axes (1st TRANSMIT)
12.5.2
Interface signals
Number
Bit
Name
Channel-specific
DB3800.DBX0001
.6
Transformation active
13
Measurement (M5)
13.1
Brief description
Channel-specific measuring
A measurement mode is programmed in a part program block (with or without DDTG). A trigger event (edge of the probe) is
defined additionally, which will trigger the measurement process. The instructions apply to all axes programmed in this
particular block. The program with the measurement process in "AUTO" mode is executed and can be employed for
workpiece or tool measuring.
Tool measuring in JOG
The control system includes operator support for the measurement process in "JOG" mode specially for measuring tools.
Channel-specific measuring is integrated into this sequence. The PLC user program must include the required functionality.
The measured offset values of the tool are available in the tool offset memory at the end of the measuring sequence.
The exact operating instructions are contained in the SINUMERIK 808D/SINUMERIK 808D ADVANCED Programming and
Operating Manual.
Note
The automatic measuring function is supported only on a milling machine.
13.2
Hardware requirements
13.2.1
Probes that can be used
General
In order to measure tool and workpiece dimensions, a touch-trigger probe is required that supplies a constant signal (rather
than a pulse) when deflected.

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English