Function Manual
01/2017
97
Skipping part program blocks:
The skip function is selected through the user interface in the following menu:
IS "Skip block selected" (DB1700.DBX0002.0) is set when the function is selected. In addition, a slash "/" must be written
before the blocks to be skipped (see figure). This however does not activate the function.
This function is activated via IS "Activate skip block" (DB3200.DBX0002.0).
The checkback signal that the "Skip block" function is active is displayed in the relevant "SKP" status line on the user
interface.
Graphic simulation
Function
In "AUTO" operating mode a selected and opened program can be simulated graphically on the screen of the control unit.
The movements of the programmed axes are recorded as line diagram after an NC start.
The graphic simulation can be reached for the selected program through the following operations:
→ Open a program →
Here the IS "Simulation active" (DB1900.DBX0000.6) is set and reset again on leaving the program editing operating area or
via the following softkey on the HMI:
Due to numerous operating possibilities a complete workpiece, or else only enlarged details of it, can be displayed on the
screen.
SINUMERIK 808D/SINUMERIK 808D ADVANCED Programming and Operating Manual
To Next Page
Loading...
Need help?
General
