Function Manual
01/2017
155
NC-Start disable without reference point
Actual value encoder type
Magnitude of modulo range
BERO delay time in plus direction
BERO delay time in minus direction
34010 REFP_CAM_DIR_IS_MINUS Reference point approach in minus direction
Reference point approach velocity
Maximum distance to reference cam
REFP_VELO_SEARCH_MARKER[0]
Reference point creep speed
REFP_SEARCH_MARKER_REVERSE[0]
Direction reversal to reference cam
34060 REFP_MAX_MARKER_DIST[0] Maximum distance to reference marker; maximum distance to
2 reference markers with distance-coded scales
Reference point positioning velocity
34080 REFP_MOVE_DIST[0] Reference point distance/destination point for distancecoded
Reference point/absolute offset, distancecoded
34092 REFP_CAM_SHIFT[0] Electronic reference point cam shift for incremental measuring
systems with equidistant zero marks.
Reference cam/reference mark distance
Axis sequence for channel-specific referencing
Status of absolute encoder
Absolute encoder range for rotary encoders
Encoder limit frequency resynchronization
36310 ENC_ZERO_MONITORING[0] Zero mark monitoring
Specific to operating mode
Active machine function REF
Position measuring system 1
Traversing key minus/plus
Reference point approach delay
Traverse command minus/plus
To Next Page
Loading...
Need help?
General
