R1: Reference point approach
15.11 Data lists
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1251
15.11.2 Signals
15.11.2.1 Signals to BAG
15.11.2.2 Signals from BAG
34090 REFP_MOVE_DIST_CORR Reference point/absolute offset, distancecoded
34092 REFP_CAM_SHIFT Electronic reference cam shift for incremental
measurement systems with equidistant zero marks.
34093 REFP_CAM_MARKER_DIST Reference cam/reference mark distance
34100 REFP_SET_POS Reference point value
34102 REFP_SYNC_ENCS Actual value adjustment to the referencing
measurement system
34104 REFP_PERMITTED_IN_FOLLOWUP Enable referencing in followup mode
34110 REFP_CYCLE_NR Axis sequence for channelspecific Homing
34120 REFP_BERO_LOW_ACTIVE Polarity change of the BERO cam
34200 ENC_REFP_MODE Referencing mode
34210 ENC_REFP_STATE Status of absolute encoder
34220 ENC_ABS_TURNS_MODULO Absolute encoder range for rotary encoders
34230 ENC_SERIAL_NUMBER Encoder serial number
34232 EVERY_ENC_SERIAL_NUMBER Expansion of encoder serial number
34300 ENC_REFP_MARKER_DIST Basic distance of reference marks for distance-coded
encoders
34310 ENC_MARKER_INC Interval between two reference marks with
distancecoded scales
34320 ENC_INVERS Linear measuring system inverse to machine system:
34330 REFP_STOP_AT_ABS_MARKER Distancecoded linear measuring system without
destination point
35150 SPIND_DES_VELO_TOL Spindle speed tolerance
36302 ENC_FREQ_LIMIT_LOW Encoder limit frequency resynchronization
36310 ENC_ZERO_MONITORING Zero mark monitoring
Signal name SINUMERIK 840D sl SINUMERIK 828D
Mode group RESET DB11.DBX0.7 DB3000.DBX0.7
Machine function REF DB11.DBX1.2 DB3000.DBX1.2
Signal name SINUMERIK 840D sl SINUMERIK 828D
Active machine function REF DB11.DBX5.2 DB3100.DBX1.2
Number Identifier: $MA_ Description
To Next Page
Loading...
Need help?
General
