EasyManuals Logo

Siemens SINUMERIK 828D Function Manual

Siemens SINUMERIK 828D
1799 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #548 background imageLoading...
Page #548 background image
K1: Mode group, channel, program operation, reset response
9.8 Block search Type 5 SERUPRO
Basic Functions
548 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
9.8.8 Special features of functions supported during SERUPRO
SERUPRO supports the following NC functions:
Traversing to fixed stop: FXS and FOC automatically
Force Control
Synchronous spindle: Synchronous spindle grouping with COUPON
Autonomous singleaxis operations: the PLC-controlled axes
Linkages: Setpoint and actual value couplings can be simulated
Master/slave for drives. These functions are closely simulated
by electronic gears. The relevant
Axial master value coupling restrictions must be considered in each case!
Axis couplings
Coupled motion: Axis grouping with TRAILON and TRAILOF,
Traverse gantry axis couplings
Tangential control: Tangential followup of individual axes
Axis functions
Axis enable,
Autonomous axis operations,
Axis transfer
Gear stage change: During program test (not fully automatically)
Overlaid movements: Superimposed motion interpolation
For more information about these functions, see the following subsections.
9.8.8.1 Travel to fixed stop (FXS)
FXS
The functionality of FOC is repeated automatically with REPOS and designated FXS-REPOS below. Every axis
is taken into account and the torque last programmed before the search target is applied.
Furthermore, the meaning of system variable $AA_FXS is redefined for SERUPRO as follows:
$AA_FXS displays the current status of program simulation.
$VA_FXS always describes the real machine status.
The two system variables $AA_FXS and $VA_FXS have the same values continuously outside the SERUPRO
function.
The user can treat FXS and FOC as special commands in a SERUPRO ASUB.

Table of Contents

Other manuals for Siemens SINUMERIK 828D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D and is the answer not in the manual?

Siemens SINUMERIK 828D Specifications

General IconGeneral
Control TypeCNC
Operating SystemWindows Embedded
ProcessorIntel Atom
Display10.4" color TFT display
InterfacesEthernet, USB
ProgrammingShopMill, ShopTurn
Operation Panel Size10.4"
Protection ClassIP65
PLC Memory2 MB
Spindle Capacity4 spindles
Hard DriveCompactFlash

Related product manuals