W1: Tool offset
18.4 Tool cutting edge
Basic Functions
1446 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
18.4.2 Tool parameter 1: Tool type
Description
The tool type (3digit number) defines the tool in question. The selection of this tool type determines further
components such as geometry, wear and tool base dimensions in advance.
Conditions
The following is applicable to the "Tool type" parameter:
• The tool type must be specified for each tool cutting edge.
• Only the values specified can be used for the tool type.
• Tool type "0" (zero) means that no valid tool has been defined.
To Next Page
Loading...
