Siemens SINUMERIK 828D

A2: Various NC/PLC interface signals and functions
1.5 Data lists
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
73
1.5.3.3 Signals to operator panel front
1.5.3.4 Signals from operator panel front
1.5.3.5 Signals to channel
Signal name SINUMERIK 840D sl SINUMERIK 828D
Screen bright DB19.DBX0.0 -
Screen dark DB19.DBX0.1 -
Key disable DB19.DBX0.2 DB1900.DBX5000.2
Delete Cancel alarms (HMI Advanced only) DB19.DBX0.3 -
Delete Recall alarms (HMI Advanced only) DB19.DBX0.4 -
Actual value in WCS DB19.DBX0.7 DB1900.DBX5000.7
Unload part program DB19.DBX13.5 -
Load part program DB19.DBX13.6 -
Part program selection DB19.DBX13.7 DB1700.DBX1000.7
File system active/passive DB19.DBX14.7 -
Part program handling: Number of the control data DB19.DBX16.7 DB1700.DBX1001.7 == 1
Mode change disable DB19.DBX44.0 -
Signal name SINUMERIK 840D sl SINUMERIK 828D
Screen is dark DB19.DBX20.1 -
Switch over MCS/WCS DB19.DBX20.7 DB1900.DBX0.7
Error (Part program handling status) DB19.DBX26.0 DB1700.DBX2000.2
O.K. (Part program handling status) DB19.DBX26.1 DB1700.DBX2000.1
Active (Part program handling status) DB19.DBX26.3 DB1700.DBX2000.3
Unload (Part program handling status) DB19.DBX26.5 -
Load (Part program handling status) DB19.DBX26.6 -
Select (Part program handling status) DB19.DBX26.7 DB1700.DBX2000.7
FC9: Start measuring in Jog DB19.DBX42.0 -
FC9 Out: Active DB19.DBX45.0 -
FC9 Out: Done DB19.DBX45.1 -
FC9 Out: Error DB19.DBX45.2 -
FC9 Out: StartErr DB19.DBX45.3 -
Signal name SINUMERIK 840D sl SINUMERIK 828D
Delete distancetogo (channelspecific) DB21, ... .DBX6.2 DB3200.DBX6.2