Siemens SINUMERIK 828D

K1: Mode group, channel, program operation, reset response
9.14 System settings for power-up, RESET/part-program end and part-program start
Basic Functions
628 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
9.14 System settings for power-up, RESET/part-program end and part-
program start
Concept
The control-system response after:
• Power up (POWER ON)
• Reset/part program end
• Part program start
can be modified for functions, such as G codes, tool length compensation, transformation, coupled axis
groupings, tangential follow-up, programmable synchronous spindle via machine data.
Example:
For certain applications (e.g. grinding) it is advisable not to apply the reset position of individual functions until the
part program start. This is possible through the appropriate setting of machine data MD20110, MD20150,
MD20152 and MD20112.
The control-system
response after:
can be set with:
Power-up (POWER ON)
*)
MD20110 $MC_RESET_MODE_MASK
(Definition of control default settings after reset/parts program end)
MD20144 $MC_TRAFO_MODE_MASK
(Selection of the kinematic transformation function)
MD20150 $MC_GCODE_RESET_VALUES (initial setting of the G groups)
RESET/part program end MD20110 $MC_RESET_MODE_MASK
(Definition of control default settings after reset/parts program end)
MD20150 $MC_GCODE_RESET_VALUES (initial setting of the G groups)
MD20152 $MC_GCODE_RESET_MODE
(Definition of control initial setting after reset)
Part program start MD20112 $MC_START_MODE_MASK
(definition of initial control system settings after part program start)
MD20110 $MC_RESET_MODE_MASK
(Definition of control default settings after reset/parts program end)
*)
see also POWER ON [Page 795]