Siemens SINUMERIK 828D

G2: Velocities, setpoint / actual value systems, closed-loop control
7.5 Closed-loop control
Basic Functions
374 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
7.5 Closed-loop control
7.5.1 General
Position control of an axis/spindle
The closed-loop control of an axis consists of the current and speed control loop of the drive plus a higher-level
position control loop in the NC.
The basic structure of an axis/spindle position control is illustrated below:
Figure 7-10 Principle representation of the setpoint processing and closed-loop control
For a description of the feedforward control, backlash, friction compensation with further machine data, and
leadscrew error compensation, see:
References:
/FB2/ Function Manual Extended Functions; Compensations (K3)
For a description of jerk limitation, see:
References:
/FB1/ Function Manual, Basic Functions; Acceleration (B2).
0'0$B$;B-(5.B(1$%/(
0'0$B$;B-(5.B02'(
0'0$B$;B-(5.B7,0(
0'0$B326&75/B*$,1>Q@
0'),32B7<3(
0''<1B0$7&+B(1$%/(
0''<1B0$7&+B7,0(>Q@
0'0$B)5,&7B&203B(1$%/(
0'0$B$;B027,21B',5
0'0$B(1&B)(('%$&.B32/>Q@
0'0$B(1&B&203B(1$%/(>Q@
0'0$B%$&./$6+>Q@
0'0$B%$&./$6+B)$&725>Q@
0'0$B)):B02'(
0'0$B)):B$&7,9$7,21B02'(
0'0$B9(/2B)):B:(,*+7>Q@
0'0$B$;B,1(57,$
0'0$B$;B0$66
0'0$B(48,9B63(('&75/B7,0(>Q@
0'0$B(48,9B&855&75/B7,0(>Q@
)LQH
LQWHUSRODWLRQ
-HUN
OLPLWLQJ
'\QDPLF
UHVSRQVH
DGDSWDWLRQ
3UH
FRQWURO
&ORVHG
ORRSFRQWURO
6SHHG
VHWSRLQW
SURFHVVLQJ
$FWXDOYDOXH
SURFHVVLQJ
,6
3RVLWLRQ
PHDVXULQJ
V\VWHP