W1: Tool offset
18.7 Cutting data modification for tools that can be rotated
Basic Functions
1532 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Response to POWER ON
The "cutting edge data modification for rotary tools" function (CUTMOD) is initialized automatically during
POWER ON with the value stored in machine data:
MD20127$MC_CUTMOD_INIT
If the value of this machine data is "-2", CUTMOD is set to the value that is set in machine data:
MD20126 $MC_TOOL_CARRIER_RESET_VALUE (Active toolholder at RESET)
18.7.8 Programming
The "Cutting edge data modification for rotary tools" function is activated with the CUTMOD command.
Syntax
CUTMOD=<value>
To Next Page
Loading...
