W1: Tool offset
18.5 Tool radius compensation 2D (TRC)
Basic Functions
1472 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Programming feed F
This feed value is effective from point P
3
(or from point P
2
, if FAD is not programmed). If no F command is
programmed in the SAR block, the speed of the preceding block is valid. The velocity defined by FAD is not used
for following blocks.
18.5.4.3 Velocities
Velocities at approach
In both approach diagrams below, it is assumed that no new velocity is programmed in the block following the
SAR block. If this is not the case, the new velocity comes into effect after point P
4
.
Figure 18-18 Velocities in the SAR subblocks on approach with G340
1RYHORFLW\SURJUDPPHG
2QO\)SURJUDPPHG
2QO\)$'SURJUDPPHG
)DQG)$'SURJUDPPHG
9HORFLW\RISUHFHGLQJEORFNROG)FRPPDQG
,QIHHGYHORFLW\SURJUDPPHGZLWK)$'
1HZPRGDOYHORFLW\SURJUDPPHGZLWK)
5DSLGWUDYHUVHLI*LVDFWLYHRWKHUZLVHZLWKWKHROGRUQHZ)FRPPDQG
3
3333
To Next Page
Loading...
