K1: Mode group, channel, program operation, reset response
9.8 Block search Type 5 SERUPRO
Basic Functions
538 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
• G331/G332 causes the spindle to be interpolated as an axis in a path grouping. In the case of tapping, the
drilling depth (e.g. axis X) and the pitch and speed (e.g. spindle S) are specified.
In the case of DryRun, the velocity of X is specified, the speed remains constant, and the pitch is adjusted.
Following the SERUPRO simulation, the position for spindle S deviates from the normal position because the
spindle S has rotated less during simulation.
9.8.3 SERUPRO ASUP
SERUPRO ASUB special points
Special points should be noted for SERUPRO ASUB with regard to:
• Reference point approach: Referencing via part program G74
• Tool management: Tool change and magazine data
• Spindle ramp-up On starting a SERUPRO ASUB
G74 reference point approach
If statement G74 (reference point approach) is programmed between the program start and the search target,
this will be ignored by the NC.
SERUPRO approach does not take this G74 statement into account!
Tool management
If tool management is active, the following setting is recommended:
Set MD18080 $MA_TOOL_MANAGEMENT_MASK BIT 20 = 0.
The tool management command generated during the SERUPRO operation is thus not output to the PLC!
The tool management command has the following effect:
• The NC acknowledges the commands automatically.
• No magazine data are changed.
• Tool data are not changed.
Exception:
The tool enabled during the test mode can assume 'active' status. As a result, the spindle may contain the
incorrect tool after the SERUPRO operation.
Remedy:
The user starts a SERUPRO ASUB that is actually traversed. Prior to the start, the user can start an ASUB
that loads the correct tool.
SERUPRO operation: Functionality: In sequence steps 2. to 6.
SERUPRO ASUB: Functionality: The sequence of point 7.
In addition, machine data setting
MD18080 $MA_TOOL_MANAGEMENT_MASK Bit 11 = 1 is required because the ASUB may have to repeat a T
selection.
To Next Page
Loading...
Need help?
General
