W1: Tool offset
18.2 Tool
Basic Functions
1426 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
18.2.3 Calculating the tool compensation
D No.
The D no. is sufficient for calculating the tool compensations (can be set via MD).
Programming
The above compensation block is to be calculated in the NC.
Part program call:
18.2.4 Address extension for NC addresses T and M
MD20096
Whether also with tool management not activated, the address extension of T and M is to be interpreted as
spindle number, can be set through the machine data:
MD20096 $MC_T_M_ADDRESS_EXT_IS_SPINO (spindle number as address extension).
The same rules then apply to the reference between the D number and T number as when the "Tool
management" function is active.
...
D
n
2IIVHWYDOXH
'3'3'3'3
'Q
'
'
'1R
To Next Page
Loading...
