B1: Continuouspath Mode, Exact Stop, LookAhead
3.8 RESET response
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
209
3.8 RESET response
MD20150
The channel-specific initial state is activated via a RESET for G function groups:
MD20150 $MC_GCODE_RESET_VALUES (RESET position of G groups)
The following G function groups are of relevance to "continuous-path mode, exact stop, LookAhead":
• Group 10: Exact stop - continuous-path mode
• Group 12: Block-change criterion for exact stop
• Group 21: Acceleration profile
• Group 30: NC block compression
• Group 59: Dynamic response mode for path interpolation
References
For detailed information about setting initial states, see the section titled"Mode Group, Channel, Program
Operation, Reset Behavior (K1)."
To Next Page
Loading...
