Siemens SINUMERIK 828D

S1: Spindles
16.4 Configurable gear adaptation
Basic Functions
1296 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Figure 16-5 Example for two gear stages with overlapping speed ranges for automatic gear stage change (M40)
Permanently defining the gear stage with M41 to M45
The gear stage can be permanently defined in the part program with M41 to M45.
If a gear stage is specified via M41 to M45 that is not equal to the current (actual) gear stage, then the following
NC/PLC interface signals are set:
DB31, ... DBX82.3 (change over gear stage)
DB31, ... DBX82.0-82.2 (setpoint gear stage A to C)
The programmed spindle speed (S...) then refers to this permanently defined gear stage:
Note
In the case of M40, the spindle must be in open-loop control mode for automatic gear stage
selection with an S word. Otherwise the gear stage change is rejected and the following
alarm is set:
Alarm 22000 "gear stage change is not possible"
Note
An active reduction gear is not considered in the selection for the automatic gear stage
change.

6SHHG
0D[LPXPVSLQGOHVSHHG
0D[LPXPVSHHGRIJHDUVWHS
0D[LPXPVSHHGRIJHDUVWHS
0D[LPXPVSHHGIRUWKHDXWRPDWLF
JHDUVWHSFKDQJHRIJHDUVWHS
0D[LPXPVSHHGIRUWKHDXWRPDWLF
JHDUVWHSFKDQJHRIJHDUVWHS
0LQLPXPVSHHGIRUWKHDXWRPDWLF
JHDUVWHSFKDQJHRIJHDUVWHS
0LQLPXPVSHHGIRUWKHDXWRPDWLF
JHDUVWHSFKDQJHRIJHDUVWHS
0LQLPXPVSHHGRIJHDUVWHS
UHYPLQ
0LQLPXPVSHHGRIJHDUVWHS
7UDQVPLVVLRQ
VWDJH
7UDQVPLVVLRQ
VWDJH