Siemens SINUMERIK 828D

W1: Tool offset
18.11 Sum offsets and setup offsets
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1569
• Wear values in the machine coordinate system
Part program instruction: TOWMCS
• Wear values in the workpiece coordinate system
Part program instruction: TOWWCS
Figure 18-52 Transformation of wear data dependent on SD42935
Programming
G-code group 56 can be used to define the following values:
Syntax Corrections
TOWSTD
Initial setting value for offsets in tool length
TOWMCS
Wear data in the machine coordinate system (MCS)
TOWWCS
Wear values in workpiece coordinate system (WCS)
TOWBCS
Wear values in basic coordinate system (BCS)
TOWTCS
Wear values in the TCS (Tool Coordinate System) at the toolholder (tool carrier
reference point T)
TOWKCS
Wear values in tool coordinate system for kinematic transformation (KCS) of tool
head






.LQHPDWLF
WUDQVIRUPDWLRQ
7RROFDUULHUZLWK
RULHQWDWLRQ
FDSDELOLW\
$GDSWHU
WUDQVIRUPDWLRQ
$GDSWHUGLPHQVLRQ
6HWXSRIIVHWRU
VXPRIIVHWFRDUVH
6XPRIIVHWILQH
7RROEDVH
GLPHQVLRQ
:HDU
7RROOHQJWK
6'6&B:($5B75$162)250
%LW 758(
%LW 758(
%LW 758(