Siemens SINUMERIK 828D

Z1: NC/PLC interface signals
19.1 Various interface signals and functions (A2)
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1651
Signal state 0 The conditions described above have not yet been fulfilled. The speed actual value is outside the
speed tolerance bandwidth.
Corresponding to ... DB31, ... DBX94.2 (ramp-up completed)
MD1426 $MD_SPEED_DES_EQ_ACT_TOL
MD1427 $MD_SPEED_DES_EQ_ACT_DELAY
Additional
references
/IDsl/ Commissioning Manual IBN CNC: NCK, PLC, Drive
DB31, ...
DBX94.6
n
act
= n
set