D1: Diagnostics tools
5.3 Service overview
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
283
References:
/FB1/ Function Manual Basic Functions; Various Interface Signals
Operating mode
Display indicating whether the motor is operating as a feed drive or main spindle drive.
Motor selection (star/delta)
Display indicating which motor data set is to be activated by the PLC. At the moment the motor data record is
used for the star/delta switchover on main spindle drives.
The following assignment applies:
The display applies only to main spindle drives.
Display corresponds to NST DB31, ... DBX21.3 to 21.4
("Motor selection A,B").
References:
/FB1/ Function Manual Basic Functions; Various Interface Signals (A2)
Actual motor (star/delta)
Display indicating which of the motor data sets is currently active. At the moment the motor data record is used
for the star/delta switchover on main spindle drives.
The following assignment applies:
Display is valid only for main spindle drives.
Display corresponds to NST DB31, ... DBX93.3 to 93.4
("active motor A,B").
References:
/FB1/ Function Manual Basic Functions; Various Interface Signals (A2)
Motor selection Application Coding
Motor 1 MSD: Star 0 0
Motor 2 MSD: Delta mode 0 1
Motor 3 reserved 1 0
Motor 4 reserved 1 1
Motor selection Application Coding
Motor 1 MSD: Star 0 0
Motor 2 MSD: Delta mode 0 1
Motor 3 reserved 1 0
Motor 4 reserved 1 1
To Next Page
Loading...
Need help?
General
