Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response
9.5 Program test
Basic Functions
502 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Selection
This function is selected via the operator interface in the "Program control" menu.
The selection sets the following interface signal:
DB21, ... DBX26.0 (skip block selected)
This does not activate the function.
Activation
The function is activated via the interface signal:
DB21, ... DBX2.0 (activate skip block)
Display
Activated "Skip block" function is indicated by a reversal of the relevant field on the operator interface.
Note
The "Skip part programs" function remains active during block searches.

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash