K1: Mode group, channel, program operation, reset response
9.9 Program operation mode
Basic Functions
562 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Signals, Alarms
Required signal states
The part program can now be enabled for execution in the channel with the START command on the condition
that certain signal states exist on the machine.
The following enable signals are relevant on the VDI interface:
• DB11 DBX4.4 (Mode group ready) must be present
• DB11 DBX0.7 (mode group reset) must not be present
• DB21, ... DBX1.7 (activate program test) must not be present
• DB21, ... DBX7.0 (NC start disable) must not be present
• DB21, ... DBX7.2 (NC stop at the block limit) must not be present
• DB21, ... DBX7.3 (NC Stop) must not be present
• DB21, ... DBX7.4 (NC Stop axes plus spindle) must not be present
• DB21, ... DBX7. 7 (Reset) must not be present
• DB10 DBX56.1 (Emergency stop) may not be present
• No axis or NCK alarm must be active
For a further explanation of the individual signals see Chapter 5.
Execution of command
The parts program or the parts program block is automatically executed and the the following interface signals
are set:
DB21, ... DBX35.5 (channel status reset)
DB21, ... DBX35.0 (program status running)
The program is processed until the end of the program has been reached or the channel is interrupted or aborted
by a STOP or RESET command.
Alarms
Under certain conditions the START command will have no effect and one of the following alarms will be
triggered:
• 10200 "No NC Start permitted with active alarm"
• 10202 "No NC Start permitted with active command" (see /DA/)
• 10203 "No NC Start permitted for nonreferenced axes"
To Next Page
Loading...
Need help?
General
