Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response
9.12 Single block
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
613
Type A, NST DB11, … DBX1.7=1 (single block type A)
- all channels are stopped.
- All channels receive a start (Start key).
- Channel KS stops at the end of the block (due to single-block)
- Channels KA receive a STOP. (analogous to STOP key).
- All channels are stopped. (deceleration phase of all KAs)
Type B, NST DB11, ... DBX1.6=1 (single block type B)
- all channels are stopped.
- All channels receive a start
- Channel KS stops at the end of the block
- Channels KA receive a STOPATEND.
(analogous with NST DB21, ... DBX7.2 ("NC stop at the block limit).
- All channels are stopped at a block limit (at some point in time).

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash