Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response
9.15 Replacing functions by subprograms
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
659
Output of auxiliary functions to PLC
When replacing auxiliary functions, calling the replacement subprogram does not initiate that the auxiliary
function is output to the PLC. The auxiliary function is only output if the auxiliary function is reprogrammed in the
replacement subprogram.
Block-search response
The replacement subprogram is also called in the search modes "Block search with calculation" and "Block
search with calculation in the program test mode" (SERUPRO). Any special features must be realized in the
replacement subprogram using the system variable: $P_SEARCH, $AC_SERUPRO.
Regarding collecting actions for "search with calculation", replacement subprograms behave just like "normal"
subprograms.

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash