Siemens SINUMERIK 828D

K2: Axis Types, Coordinate Systems, Frames
10.5 Frames
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
741
Parameterization
Frame suppressions SUPA, G153 and G53 lead to the WCS, SZS and possibly the BZS jumping when frame
suppression is active. This characteristic for position display and pre-defined position variables can be changed
through the following machine data:
MD24020 $MC_FRAME_SUPPRESS_MODE (Positions during frame suppression)
When the bit is set, the position for the display or the variables is calculated without frame suppression so that no
further jumps in the position occur.
Bit Significance
0 Positions for display (BTSS) are without frame suppression.
1 Position variables are without frame suppression.
:&63&6
6=6$&6
%=6)&6
%&6%&6
0&60&6
.LQHPDWLFWUDQVIRUPDWLRQ
+DQGZKHHO'5)RIIVHWVXSHULPSRVHGPRYHPHQW]HURRIIVHWH[WHUQDO
5HIHUHQFHSRLQWRIIVHW
683$
*
*
3B75$)5$0(3B3)5$0(
3B,62)5$0(3B&<&)5$0(
3B722/)5$0(3B:3)5$0(
3B3$57)5$0(3B6(7)5$0(3B(;7)5$0(
3B,62)5$0(3B,62)5$0(3B,62)5$0(
3B,)5$0(
3B$&7%)5$0(