Siemens SINUMERIK 828D

P3: Basic PLC Program for SINUMERIK 840D sl
13.2 Key data of the PLC-CPUs for 840D sl and 840Di sl
Basic Functions
844 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Version screen according to the module state in STEP7 Online
If, using STEP7 Online, you connect to a PLC integrated in SINUMERIK, there, under the "General" tab, you can
determine the hardware version of the PLC module as well as the PLC firmware version.
The following versions are available:
PLC basic program functions
Hardware
Product version
PLC module
Firmware version
1)
Designation
SW version operating
system
2)
20xx
PLC317-HW of the
840Dsl
PLC 317-2DP
with IBC32
V 2.1.10 20.70.41
21xx
MCI 2 Board (840Di)
PLC 317-2DP
with IBC32
V 2.1.10 20.72.41
23xx
PLC319-HW of the
840Dsl
PLC 319-3PN/DP V 2.4.2 24.90.13
V 2.6.5 26.90.13
V 2.7.2 27.90.06
1)
Firmware release: Version of the SIMATIC CPU and specification of the SIMATIC hotfix, from which
the SINUMERIK PLC CPU is derived (e.g. V-2.1, HF10; or V-2.7, HF2).
2)
The last two positions of the software version are used within SINUMERIK to assign a PLC version
Type of control
840Di 840D sl
Scope
Axes/spindles See catalog 31
Channels 6 10
Mode groups 6 10
Functions
Status/control signals + +
M decoders (M00-99) + +
G group decoders + +
Aux. function distributors + +
Aux. function transfer, interrupt-driven + +
M decoding acc. to list + +
Move axes/spindles from PLC + +
Async. subprogram interface + +
Error/operating messages + +
Transfer MCP and HHU signals + +
Display control handheld unit + +
Read/write NCK variables and GUD + +