Siemens SINUMERIK 828D

7.6.2 Connection
Electrical connection diagram
The handheld handwheel is connected via a flange socket using the spiral connection cable.
You will find article numbers for the recommended flange socket in Chapter Spare parts and
accessories (Page 178).
6KLHOG
1RWDVVLJQHG
;8
%
9'&s
ZKLWH
EURZQ
JUHHQ
\HOORZ
JUD\
SLQN
/HJHQG
ZV
EU
JQ
JH
JU
UV
ZV
EU
JQ
JH
JU
UV









56$
$
$
%
%
;9
;$
;$
;%
;%
Note
If a connected handwheel triggers pulses while in the idle position or when there is only minimal
contact, connect it the opposite way round to what is stated on the label.
Swap:
● The wires of terminal A with those of terminal /A
● The wires of terminal B with those of terminal /B
Anschließbare Komponenten
7.6 Electronic handwheel
PPU and components
176 Manual, 05/2015, 6FC5397-2DP40-3BA4