Emergency Stop circuit
EMERGENCY STOP
Press the Emergency Stop button in the following situations:
● When persons are at risk.
● When there is a risk of the machine or workpiece being damaged.
As a rule, when operating the Emergency Stop button, all drives are brought to a standstill with
max. braking torque. Turn the Emergency Stop button counter-clockwise to release it.
7.1.2 Mounting
Installation and mounting
The recommended machine control panel mounting is shown in the following diagram:
The machine control panel is mounted from the front in a rectangular cut-out and attached
using tension jacks (0.5 Nm tightening torque). The tension jacks are included in the scope of
delivery. Tension jacks are also available as a spare part, see Section Spare parts and
accessories (Page 104).
Anschließbare Komponenten
7.1 MCP 483 USB
PPU and components
Manual, 05/2015, 6FC5397-2DP40-3BA4 95
To Next Page
Loading...
