To Next Page

To Previous Page

7.1.3 Connecting

Connections (rear)







0&386%

① Ground terminal

② USB connection for communication with the PPU, X10 NC

③ Slots for control devices (d = 16 mm)

Figure 7-4 Connections at the rear

USB 2.0 interface

The machine control panel is connected to the PPU using a USB cable. The machine control

panel is also supplied with power via this USB connection. The USB cable is included in the

accessory pack of the machine control panel.

You can also connect the machine control panel via an industrial USB hub

(6AV6671-3AH00-0AX0).

Pin assignment of the USB connection

Connection designation: X10 NC

Connection type: USB socket, type B

Maximum cable length: 0.8 m

Type B socket Pin Signal name Signal type Meaning







1 P5V V + 5 V

2 Data-

Data -

3 Data+ Data +

4 GND V Ground

Anschließbare Komponenten

7.1 MCP 483 USB

PPU and components

Manual, 05/2015, 6FC5397-2DP40-3BA4 97

Siemens SINUMERIK 828D Manual

Other manuals for Siemens SINUMERIK 828D