Siemens SINUMERIK 828D Manual

7.10.2 Mounting
Designs
The NX10.3 is integrated into the SINAMICS drive line-up. For the preferred installation
sequence, the NX module should be mounted at the side of the Line Module.
NOTICE
Protection against overheating
The 80 mm ventilation spaces above and below the components must be observed.
Anschließbare Komponenten
7.10 NX10.3
PPU and components
248 Manual, 05/2015, 6FC5397-2DP40-3BA4

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash