2.7 Connectable components
Component overview
The following components can be connected to the PPU:
● Machine Control Panel MCP 310C PN, MCP 483C PN
Contains the keys and switches required for the operation of a machine (turning or milling
machine).
● Interface module MCP Interface PN
The MCP Interface PN module enables customer-specific machine control panels to be
connected. Further, a 3rd handwheel can be connected via the module.
● Handwheels
A maximum of three handwheels can be connected.
● Mini handheld unit
A mini HHU can be integrated into the SINUMERIK 828D system using a connection kit.
● I/O modules PP 72/48D PN / PP 72/48D 2/2A PN
The modules are used to connect digital as well as analog inputs and outputs. To supply
the module and the outputs, an external power supply unit (24 VDC) is required, which
provides safety isolation from dangerous voltages.
● GSM modem
Connection of a SINAUT MD720-3 GSM modem for sending and receiving SMS messages
(Easy Message) via the serial RS232 interface.
● PN/PN coupler
A PN/PN coupler can be connected in order to link a SINUMERIK 828D to PROFINET
networks.
● SENTRON PAC 3200/PAC 4200
The connection of a SENTRON PAC 3200 / PAC 4200 makes available functions for
increasing the energy efficiency of machine tools.
SINAMICS S120 drive system
Only the SINAMICS S120 Line Modules and Motor Modules are used for drive control. Motor
Modules can be used to connect servo motors as type 1FK7, 1FT7, and 1PH8 feed and main
spindle motors. Type 1FW6 torque motors can also be connected.
See also
Anschließbare Komponenten (Page 93)
SINAMICS components (Page 85)
● Interface overview (Page 67)
● Auto-Hotspot
System description
2.7 Connectable components
PPU and components
Manual, 05/2015, 6FC5397-2DP40-3BA4 29
To Next Page
Loading...
Need help?
General
